Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I'm planning to connect 5 campus locations which are close to 350 meters from my 4507R-E core.My plan is to lay single mode fiber to the core, my questions are.1. Planning to buy Ws-X4606-X2-E, in this module do i need to buy X2-10Gb modules...
Dear all,I'm planning to connect 5 campus locations which are close to 350 meters from my 4507R-E core.My plan is to lay single mode fiber to the core, my questions are.1. Planning to buy Ws-X4606-X2-E, in this module do i need to buy X2-10Gb modules...
Dear all,in my H.O i have a 2801 with VWIC2-1MFT E1/T1 and i have an E1 leased connection which is 2.048Mb, and at the branch sidei have 1841 and ISDN BRI card and my ISDN BRI connection is ready at remote branchi need to connect between these 2 offi...
hi james,thank you for your reply.i have couple of doubts.as i have explained in my first post, i have a leased line which is E1 and for sure i can channelize it. suppose site 1 using BRI so the site 1 router need to dial into my H.Q correct me if i'...
i need remote client vpn.i'll explain my scenario. i have one 4mbps ADSL connection at H.O, that is the only available internet connection. so i dont have a static public ip address.now my question is how can i configure an asa 5510 for ipsec vpn usi...
helloyou can have even a router with advanced enterprise IOS.first of all i'm not aware of your set up.i'll explain 1 scenario which i did, i have a 2821 router at the H.Q and 20 branches at remote locations. at remote locations i'm using cisco 877 a...
