Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i'd like to convert one of our new sites to the network without re-ipping the site to fit our subnets. Can i do some static natting between 192.168.1.0/24 (existing network) and 10.248.108.0/24, which will allow me to route and use the existing 192.1...
How can i create an etherchannel for 2811 router (My MPLS Router) with LAN interfaces bundeled(fa0/0 and fa0/1) both connected as an access port Vlan 80 to a layer 3 stacked Cisco 3750 switches Port#1 and Port#25. Cisco 3750 has a bunch of sub interf...
Can i get some help to turn on net flows on my cisco router. I have T1 connection (s0/1/0) and FE port with different sub-interfaces. I want to monitor all my traffic going out the s0/1/0 (WAN) interface.
How can i create Differents VLANs on 1310 Root bridge and pass the VLAN info to the non root bridge wirelessly.Currently my switch ports are configured as access port for the bridges and if i make the port a trunk port; siwtch connected to the non r...
John,Actually i am trying to do Static Nat and dynamic as well at the same time. Although it is trivial but i think thats the only option i have.How will it work if i have a webserver. will i be able to do port forwarding with static nat which means ...
I have upgraded the IOS on the 2811 to (12.4(17.6) and also upgraded the IOS on my 3750 stack with c3750-ipservicesk9-mz.122-44.SE.Also will the following configs work. Feel free to throw in any extra commands that will improve the config.********Eth...
Thanks. My IOS does not support ip route-cache flow. Can i use ip flow ingress and ip flow egress as a replacement for the route-cache flow command.Also is F0/1 lan interface or the WAN interface.Thanks,Osman
Yes Guarav. Actually i want everything allowed to the tunnel interface and restrict internet access to HTTP, HTTPS and DNS.All Lan traffic will be on VLAN 10.Not sure where to apply those acls and what direction it should be.Fas0 - LAN interfaceFas4 ...
