Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cannot associate 7921g with 851W with LEAP autentfication. When set autentification to Open - all is ok. Config from 851w below:aaa new-modelaaa group server radius rad_eap server 172.16.1.100 auth-port 1812 acct-port 1813!aaa authentication login ea...
Suggest me please how I can see number of active routes recieved from some bgp neighbor? Like juniper system that show number of recieved prefixes and number of prefixes from this neighbor that are installed in routing table.
Does anyone know why in eigrp configuration in no passive-interface set, when creating new interface vlan it is automatically add to no passive-interface. Why it is occur and how I can turn off it?
What are the phisical limitation on sup32 platform without OSM modules because VPLS is cann't run?sup32 can do l2tunnels and allow to configure vfi in Version 12.2(33)SRA2, what are the OSM modules hardware provide that are such needed for VPLS?
encryption mode wep mandatory - exist only at interface parameters, I've add it but nothing happens.Exist any way to see debuggin information about errors due wireless negotiation/autentication?
Or with reocmmendation on previous post you may configure stormcontrol multicast with hard limitation on access port to filter near source of this traffic.
