Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I have Cisco 837 ADSL Router and 1Mbps Internet. Is it possible to distribute bandwidth on its four ethernet ports? Secondly, is it possible to access its Web Interface in IE7 or IE8. I have tried a lot but it only works in IE6.Apologize if this i...
Hi!I have two Cisco 2960 Switches. Is it possible to use them to allow computers having specific MAC Addresses only and restrict all others or is there any other way to restrict the computers from reaching my internal network that are not part of my ...
Hi!I have a point to point network for a branch to my head office. I need to connect it to my Internal Network Switch 3750 port. I have a spare PIX 515E that is not in use. My question is that what will be better choice both security wise and speed w...
Hi!I have PIX 515E which i want to install on my network for Internet Security. Can i connect PIX LAN Interface to my LAN Switch where all the servers are connected. My Internal Users will use ISA Server as a webproxy and caching and my branch users ...
But its not. It is working in IE6 and IE7 but not in IE8 even with compatibility view and showing "Error on Page" on the left side of it's browser window.Thanks!
Yes i have the same but the problem is that it is not dhcp enabled and i am unable to connect to it. Is there a way i can reset it to the factor defalut settings?Thanks!
Thanks very much. This is what i needed to know.Now if i change pix inside interface IP like 192.168.22.1 then what configuration is needed to allow 192.168.21.11 connect to my Terminal Server on 192.168.21.2 through the mapped public ip of pix.Thank...
