Hi All,Since unlike 2960x or old model routers/switches, can show run to check the command.I'd like to seek some help how to check the below commands about "unused services" on C9200/9300.Because I cannot find documentations on internet, or it's alre...
Can the Cisco PI Compliance Policy feature check if "spanning-tree portfast" is configured on each interface currently configured?Some information is found in the official documentation, but only some examples are described, such as SNMP/NTP/IOS vers...
Hi All, We would like to modify the configuration via SNMPset command but unfortunately now the SNMPv3 was configured to Read only.Any experts here could advise?snmpset -v3 -l authPriv -u <SNMPv3 USER> -a MD5 -A <PASSWORD> <SWITCH_IP> .1.3.6.1.4.1.9....
Hi All,Any advise for SNMPv3 to push the configuration, due to seems look like only SNMPv2 can I found.SNMPv3snmpset -v 3 -u USERNAME -l authPriv -a SHA -A AUTH_PASSWORD -x AES -X PRIV_PASSWORD DEVICE_IP_ADDRESS 1.3.6.1.4.1.9.9.96.1.1.1.1.2.XXX i 1sn...
I have same issue on this PI version 3.10.2 and I did the same things with distribution to my 3650, then it is also reboot even I unchecked "Insert boot command" and I left with "Smart Flash Delete Before Distribution" checked.
