Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On packet tracer, I set up RIP via the GUIs on two routers that I want to connect via a WAN. One of the routers can be pinged to its serial port from devices on the external network side and it can be pinged to its ethernet port from devices on it's ...
Hi, on packet tracer I have made a VLAN. My 4 Client devices in the VLAN can ping the switch. I can't ping from a client device to the router through the switch though. The link to the router comes out of Fast Ethernet 0/5 on the switch and into Fast...
Thanks, I am now able to ping the ethernet port of a router from the router on the other side of the WAN. That shows that some packets are able to get through the serial port of that router and out of the ethernet port on it. I still can only ping th...
Thanks:) I've enabled IP routing on the L3 switch through the CLI; I'm hoping that I can get to the point where I can connect the default gateway to a WAN but for that I think I will need to use RIP or a routing protocol. I'm looking into RIP right n...
Hi, I have now added a L3 switch as a central switch but I am still having trouble pinging packets from my original switch to the L3 switch. And I'm not able to ping packets between my gateway and the L3 switch yet either. many thanks if you are able...