Hi, I'm connecting a brand new out of the box Fortigate 60F to the N2K FEX in our ACI mini lab and after configuring the port in APIC it goes into an 'bpdu-guard-err-disable' state. I know that FEX has bpdu guard on by default and you cannot disable ...
Does Cisco support onboarding 2 x 9500 Stackwise Virtual switches to DNAC via PnP?
Is what is covered in this thread officially recommended by Cisco? Perhaps someone from Cisco can post here and confirm what the workflow should be for onboarding 9500...
You need to configure the Stackwise Virtual settings manually on the 9500 switches before starting the PNP process. Once the switches are in a virtual stack, you can proceed with PNP, and it will treat them as a single entity for configuration and ma...
Hi All,
I would also like to know why removing the vrf statement from the pool works. I just ran into this exact same problem but it still doesn't make sense to me why remove the vrf command would make this work as the SVI is in a different vrf?
I ...
I figured it out. The problem wasn't on the ACI side. On a Fortigate 60F interfaces 1-5 are configured into virtual switch called 'Internal'. This must have been sending BPDUs towards the FEX. Once I disabled the virtual switch everything worked.
No ports are in use on the FEX currently. When looking at the FEX on the inventory tab in APIC I can see that every port is in an oper mode of trunk. I'm not on site at the moment so cannot remove cables. Earlier I did try different ports on the FEX ...
