Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got a catalyst c9800 WLC and I was trying to manage it over the wireless network and can't. I can't find where to enable this or if it's something that has to be done via CLI or what. Most of my APs are in Flex-connect mode as well. It's running...
new 2802i AP installed in remote branch. Finds WLC via DHCP option 43. After I get it configured to be flex connect, the WLAN that I have 802.1x configured on isn't working. Looking at my NAS it's saying that the IP address of the AP is sending the R...
I'm upgrading my companies wireless system. Going from a 2504 WLC to a Catalyst 9800 WLC with 2802i APs. As far as I can see (on my Cisco Smart Licensing account) the WLC and the AP are registered and licensed. The AP can associate with the controlle...
I've got a 2504 WLC with AIR-CAP2702I-A-K9 APs. Software on the WLC is 8.0.132.0 Issue is with a single WLAN when getting IP addresses via DHCP. These APs are in local mode as well, so CAPWAP tunnel is built to the WLC.This SSID is in the 10.2.1.x ne...
So as the title says, I've got some really odd things going on to seemingly random workstations. Thankfully only a couple so far. So I can't reach these workstations outside of their physical location. From their switch I can ping them. I've used ext...
Thank you. I'm aware of that it's not recommended. Most of my deployment is flex-connect APs with local switching and ACL's on those switches prevent traffic from the VLANs/SSIDs to the WLC. The WLAN I'm accessing the WLC from is pretty secure, with ...
Found the answer on another thread. Not really in an intuitive spot. Configuration > Wireless > Wireless Global > enable Management via Wireless........ You'd think it'd be under Administration > Management.....
I'm not sure how it was working, but it was. It could very possibly be that I had central authentication enabled and didn't know it. I wasn't confused so much with the local/central authentication and switching. I read documentation the other day tha...
Thanks for your input. I have a question, though. Is this something new? My previous deployment (2504 WLC with 2702i APs) were not acting as the supplicant, it was the switch. I didn't have any of the AP devices added to my RADIUS server but only the...
