cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
417
Views
0
Helpful
3
Replies

2802i AP not broadcasting any SSID on either band.

bbabbmcl4214
Level 1
Level 1

I'm upgrading my companies wireless system. Going from a 2504 WLC to a Catalyst 9800 WLC with 2802i APs. 

As far as I can see (on my Cisco Smart Licensing account) the WLC and the AP are registered and licensed. 

The AP can associate with the controller. I can see the AP and configure things on it. I just don't see any SSIDs being broadcasted and looking at the AP it's saying the 'Operational status' of the radios are down. As far as I can see I've got both 2.4 and 5ghz radios enabled. 

Where am I missing settings? 

Thanks.

1 Accepted Solution

Accepted Solutions

Wes Schochet
Level 3
Level 3

Are these new APs? Sounds like the APs don't have enough power. You are going to need POE+ to get those going. 

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9100-access-points/215467-cisco-access-point-power-requirements-qu.html

View solution in original post

3 Replies 3

Wes Schochet
Level 3
Level 3

Are these new APs? Sounds like the APs don't have enough power. You are going to need POE+ to get those going. 

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9100-access-points/215467-cisco-access-point-power-requirements-qu.html

Thanks for the reply.

I've thought of that and actually have this AP hooked up to a PoE injector at the moment. Just hooked that up a few hours ago. 

Looks like the injector wasn't plugged in correctly. Thanks. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: