Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Can anybody please advise on the configuration for the clock on these 2960 S switches? We have used: clock timezone GMT 0clock summert-time bst recurringWhen you do 'Show Log' the clock is an hour behind. When you do 'Show Clock' it shows the ri...
Hi,I’m trying to load a new IOS onto a 2960s Stack, but unable to use the “archive download-sw tftp://[IP]/[IOS]. I have tried this with a .bin and .tar, but get this EM:%Error opening flash:update/info (No such file or directory)ERROR: Image is not ...
Hi, I have been trying to load "IPS-engine-E4-req-6.0-6" & "IPS-sig-S536-req-E4.pkg" onto the IDS boxes that at present have "IPS-K9-6.0-6-E3" & "IPS-sig-S479-req-E3.pkg" installed.However, when I tried to Upgrade the signature, I get:"Cannot upgrad...
I was trying to 'copy tftp flash' to a switch, after deleting the original IOS, due to reasons, that were beyond my control, I was unable to complete the task, and without thinking, I switched the switch off!! Bad move!! How can I sort this out: Err...
I have reloaded this box a couple of times, the version is Cisco Intrusion Prevention System, Version 6.0(6)E3I have also tried to just load the engine and tried an array of loading sequences between the .pkg upgrades i have (listed on the last doc i...
