Jerems
Spotlight
Spotlight
Member since ‎06-28-2021
‎10-07-2024

User Statistics

  • 175 Posts
  • 12 Solutions
  • 129 Helpful votes Given
  • 119 Helpful votes Received
Recent Badges
70 Discussion Posts
60 Replies
40 Discussion Posts
40 Helpful Vote
40 Replies
50 Helpful Vote
5 Discussion Posts
5 Helpful Vote
50 Discussion Posts
30 Replies

User Activity

Hi dear community,How can this happen ?Two dot1q headers on a captured MPLS frame going out from a Cisco ISR 1111-8P acting as a PE.Thanks in advance for your help !Regards,Jerems
Hi dear community,I am facing an issue with the following setup :Ping is not OK for the BGP EVPN VPWS Service (Vlan / EVC 20).Here is the configuration of the involed PE :Cisco PE ISR1111:interface GigabitEthernet0/0/1 no ip address negotiation aut...
Hi dear community,Do you know why, when we open a pcap file with wireshark where we have MPLS packet captured, we always have to "Decode As" to see the entire MPLS Header ?Thanks in advance for your kind help,Jerems 
Salut la communauté,Savez-vous si la même valeur MTU est attendue sur une telle topologie entre un ISR4321 et un SRX300 pour fonctionner correctement ?  Jun 5 20:25:00.568: XC VFI CFG[VPLS-14121]: Add BGP sig member vpn_id [14121] Local VE[id:41, la...
Hi Guys,Do you know if a the same MTU value is expected on such topology  between a ISR4321 & a SRX300 to work properly ? Jun 5 20:25:00.568: XC VFI CFG[VPLS-14121]: Add BGP sig member vpn_id [14121] Local VE[id:41, label:42] Remote VE[id:1, label:2...
Community Statistics
Member Since ‎06-28-2021 06:44 AM
Date Last Visited ‎10-07-2024 11:40 AM
Posts 175
Total Helpful Votes Received 119
Awards
Community Spotlight Award
English Community, Developer of the Month, March 2022