Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure a couple community and isolated private vlans. Successfully specified the primary and secondary (community/isolated) vlans but when I want to specify the promiscuous port I simply don’t get the option to enter: switchport mod...
To my knowledge the catalyst 91xx access points should be able to play nicely alongside their older Aironet 3802 series counterparts, but I am starting to question if this is actually the case with the 9120 EWC mode.I have been trying to add two Airo...
Hello everyone,I was cleaning up my rack today and was wondering if it is possible to upgrade the M.2 LTE module found in the 1000 series ISR. On the Sierra Wireless website, there are many M.2 modules listed that offer greater speeds over the 300 Mb...
Hi all, I was wondering what the function is of the port labelled with number 15 in the diagram below:it is labelled as an LTE Provision port.I was looking to find a way to configure LTE band aggregation recently. Is it configured through this port? ...
I recently tried managing a 3802i AP through the Cisco Catalyst Wireless App. It is running in Mobility Express mode and is running as a controller for the network.I am getting a "Unable to reach the server. Please check your connectivity" error when...
Thanks for the quick reply!I tried switchport access vlan <primary>Then when trying:switchport mode ?I still gett only the option for:access | dynamic | trunk.Were you able to find out if this feature is supported?I think I simulate community private...
I am starting to suspect that this feature of private-vlans is not supported on the ISR 1100 series. Weird that it lets you create a vlan and set it as a community/isolated private-vlan.Wondering if I can work around this for the part of the network ...
Highly appreciate your answer!I did make the association without the word "add" so I tried again but unfortunately without any luck. The situation is still unchanged.When I run:show vlan private-vlanThe primary and secondary vlans are listed but unde...
Thank you for your reply!When doing this I get:switchport% incomplete command.--------------------------------------switchport ? access Set access mode characteristics of the interface autostate Include or exclude this port from vlan...
