Hi,
I have a customer with Anyconnect always-on configured, and users should not connect while on the the internal LAN. Is there a way to disable this feature?
I have a customer with an ASA 5550. The customer recently failed a PCI compliance audit. The solution is enable TLS 1.2 which is only supported starting with the 9.3x code. The 5550 does support this version of code. Is there currently a work around ...
Switch was shipped with ACI mode, and I am trying to convert it back to standalone mode. I have the NX-OS image on the switch, however; the it will not boot into NX-OS from loader prompt. Can anyone assist?
I am attempting to convert a Nexus 9396 from ACI to standalone mode. i've followed the some online documentation. The image is in the bootfash:
n9000-dk9.6.1.2.I3.4b.bin. I configure the switch to boot the image. and I get the following error. Is the...
I had this this same issue and I resolved with the help of TAC. I changed the MTU on the diagnostic interface to 1450 and that resolved my issue. Migration tool went through successfully after that. Now I'm just hoping I don't have some weird behavio...
Yes I am attempting to convert back to standalone mode. I am trying to load image n9000-dk9.6.1.2.I3.4b.bin, and below is the error I receive.
Trying to read config file /boot/grub/menu.lst.recovery from (hd1,4) Filesystem type is ext2fs, partition...
