Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Can anyone please suggest me what is the criteria for a WLC to become a RF group leader and how is a Group leader is different from rest of the WLCs in the RF group. On what basis the RF group leader is elected. Is it on the basis of Lowest MA...
Hi All,Just a basic question regarding MAC based authenitcation of AP with ACS. The scenario is - If I have a ACS installed and I want all my Cisco 3502 APs to be authenticated on MAC basis via ACS. I know that AP mac is used as a username and passwo...
Hi,Just a basic querry, Although I know the difference between 802.11 a and 802.11 g standard but just confused about this. When both the standards have been originated from OFDM and provides maximum Data rate of 54 Mbps. They have almost similar fea...
Hi,My As are not joining the WLC 5508. I am getting the following error on my WLC :*Feb 24 21:31:00.144: status of voice_diag_test from WLC is false*Feb 24 21:31:10.000: %CAPWAP-5-DTLSREQSEND: DTLS connection request sent peer_ip: 10.79.112.15 (WLC ...
Thanks Steve. That was simple one liner answer to my question. It clears my confussion now. Earlier I was thinking that AP MAC will be verfied first by ACS and then only it will be allowed to talk to WCL. I was wrong in that.
Hi Amjad,Thanks for your reply. But I am still confused about this. If the AP is new and just started booting up. The First thing it should do is - Going to the ACS and get itself verified and authenicated to join the controller. After the successful...
I faced the similar issue long time back. The solution is to use the root command on Windows CLI. e.g. route ADD 157.0.0.0 MASK 255.0.0.0 157.55.80.1 METRIC 3 IF 2 destination^ ^mask ^gateway metric^ ^ ...
No... That may be your laptop issue as well. The same thing happend with me too. It worked good with the Laptops having direct console port on it. Incase you will try to use the console convertor to get access of that AP, it won't give it. So Try to ...
