Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,switch>enableswitch#conf tswitch(config)#interface VLAN1switch(config-int)#ip address AAA.BBB.CCC.DDD 255.255.255.0 <-- use IP address and mask from your networkswitch(config-int)#no shutswitch(config-int)exitswitch(config)#ip default-gateway 1AAA...
Hi,please check the 10-Gigabit Ethernet Transceiver Modules Compatibility Matrix for the right IOS Version.http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6974.htmlregardsUdo
Hi,no, you has to use 24V DC.The Catalyst 2955 switch is an Ethernet switch that mounts on a DIN rail in an industrial enclosure.The 2955 switch can be used with an optional AC/DC power converter (PWR-2955-AC=) in a nonhazardous location installation...
Hi,you can use the ME3400 in in a cascaded configuration.please see:http://www.cisco.com/en/US/docs/switches/metro/me3400/hardware/installation/guide/3400hig.pdfThe Cisco ME switch supports the SFP module patch cable, a 0.5-meter, copper, passive cab...
