Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i have 2 simple questions Is it possible to stack the ME3400 switch? If yes, what cable do i need to use in this stack.If no, is it planned for future?I really appreciate your help (replies) on this.Regards.
Hello all, have anyone had an issue with CW assistant?After i click on Server Setup under CW assistant, after couple minutes i'm getting an error message saying: Server discovery timed out. Please try again later. Do you know where can the problem be...
Hello, is it somehow possible to configure a DHCP server tracking and to backup it by Cisco DHCP solution. To be more clear, I would like use Cisco DHCP feature on the router to act as a backup DHCP in case of my DHCP server (or link to it) fails.Tha...
Hello, where could i find some actual information about the compatility of 6503, 6503-E chassis and their interfaces. To be more exact, i'm looking for the information, if the WS-X6724-SFP interface card is compatible with 6503 or 6503-E. If so, what...
Mav, to answer you question about what would happened if one link fails, i'd need more details... just to avoid wrong (misleading) help from my (our) part. It all depends on your inter AS routing, physical and logical architecture. For the documentat...
Mav, to be more precise, not only to BGP peers, but to be able to advertise the prefix to ANY bgp peer, you need to have the same prefix already in routing table. As you're getting MORE specific prefixes from your iBGP, you have two possibilities. 1....
Hello Mav, so, if i understand it well, the main problem/question you have is why those static routes. The answer is, that this is the way of working of BGP. If you want BGP to advertise any route (prefix), before advertising, BGP checks the routing ...
