Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
I have set our Ironport incoming content filter to quarantine all emails that have exe and zip attachments. But we still need to receive zip files from some legitimate senders. How do I exclude some senders from the filter so they can send zi...
Hi, We have ironport c170 and Exchange 2010. Our GoDaddy certificate is installed on the exchange server and is enabled for SMTP. We want to enable TLS on the ironport but we have to install a certificate there as well to match the domain name so m...
Hi,is it possible to configure a Cisco 881 router to split the incoming internet connection between two ASA's? If one ASA fails then the router would switch traffic over to the second ASA. The 2nd ASA would takeover from the primary ASA through the a...
Hi,I have exisitng setup of router > ASA > unmanaged switch > LAN. I want to setup 2nd ASA as failover with crossover cable but im stuck on how to 'share' the internet connection with the 2nd ASA. Am i correct to think that both ASA's would need to...
Hello,I have idle timeout set to 10 mins for our IPSEC vpn group, however the tunnels are not disconnected when idle because data is still being sent/received by something. i checked the statistics for the vpn client and can see bytes being sent/rec...
hi thanks, so: keep the cert on the exchange and remove SMTP but keep IMAP etcexport the cert and install on the ironportchange default receive connector FQDN to something else can you clarify the last bit again - "if you want TLS between exchange a...
its a SAN on the Exchange - the name matches our MX record, we run OWA and IMAP also on the Exchange. The cert on the Ironport must match our MX record. So do we just move the cert from the server to the ironport because thats where the emails are r...
