Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can not see any packets on the physical interface but the multilink interface shows packets, i would like to know the cause for the samesho inter Serial5/0/0/5:0 | in s/s 30 second input rate 0 bits/sec, 0 packets/sec 30 second output rate 0 bits...
Can somebody help me understand the cause for no-buffer drops counters to be increasing. I have tried increasing the queue limit on standard class, Even after that i see the drops to be increasing.Truncated show policy ouput Class-map: class-defau...
Hi, Is there any way to disable syslogs generated for an asynch interface. Nov 19 15:31:30.571 UTC: %CIRRUS-5-LINEFLAP: Unit 2 excessive modem control changes Nov 19 15:32:00.572 UTC: %CIRRUS-5-LINEFLAP: Unit 2 excessive modem control changes Nov 19 ...
Hi All,Can somebody tell me why input error counter do not increase on multilink interface when there errors observed on the physical interface, Since Multilink interface is being polled i do not get alerts when there is errors on the physical interf...
Hi Whiteford,you can send logins attempted messages to syslog server by enabling the following command"login on-success log [every login ]"There is another command to track failed login attempts" login on-failure log" This feature is available for io...
Hi,if your requirement is to run few set of commands on multiple routers. Then the best way is to use a utility called as Kiwi CAT. With this you can configure the required set of commands for mulitple devices and schedule it.RegardsSanthosh M.CCable...
