Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am preparing to build a LISP environment based on the commands listed on this site.I am researching the details of two commands,https://www.cisco.com/c/ja_jp/td/docs/routers/C8000V/Azure/deploying-cisco-catalyst-8000v-on-microsoft-azure/configure-l...
I am using LISP to migrate virtual machines on the same segment between DC1 and DC2.There are two segments to be migrated.The Gateway will be an on-premises L3switch.1.10.1.0.0/24 Gateway IP: 10.1.0.254 (L3SW)2. 10.2.0.0/24 Gateway IP: 10.2.0.254 (L3...
In researching configuration information, I have checked the following Cisco site.Cisco Catalyst 8000V Edge Software Deployment in Microsoft Azurehttps://www.cisco.com/c/en/us/td/docs/routers/C8000V/Azure/deploying-cisco-catalyst-8000v-on-microsoft-a...
Where is the default gateway for the relocated devices when relocating on-premise devices to Azure?On-premise PCs are to be relocated using Cisco's LISP.The default gateway of the PC to be moved is currently facing the L3SW address (192.168.10.254).W...
What is the default when Proxy xTR and PETR features are enabled?Will all communication flow from the on-premises Router to the Internet environment?If we want to enable communication flow to the Internet on each router, do we need to configure each ...
Hello @Enes Simnica Thank you for your reply.I also have a question about nbr-proxy-reply requests 3.I am guessing that nbr is a command that looks for neigbhor such as ospf or bgp.This is also a guess, but I think that the adjacent device (L3SW) wil...
Hello @Enes Simnica Thank you for your detailed explanation on how to troubleshoot the problem.As a result of our isolation, we are applying Dynamic-EID in LISP.“lisp mobility subnet1” option ”nbr-proxy-reply requests 3I was able to confirm communica...
Hello @Enes Simnica Thank you for your response.I have considered writing a route on a stick,I can't write the routing because the devices on this configuration are on the same segment.When the GW of terminal1 is set to 10.1.0.254, arp-request from L...
