Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Many thanks to the community for tolerating some of my questions and helping me learn more about Cisco routers. Recently, a user helped me to get NAT running on our router using a single IP address on
GigbitEthernet0/0/0
to a corporate network. For a...
Good day, all. I am still very fresh when it comes to Cisco routers and how some things are accomplished so please forgive my ignorance.
We have a recently acquired Cisco C1111 router that we are using to route between multiple private range subnets ...
Good day, all.We have a fresh out of the box C1111-8P router. I am attached to the console and have completed the basic configuration which is a fairly straightforward process. In following the manual Chapter: Setting Up Factory Default Device Using...
Good day, all. To date people here have been very helpful and believe me when I say that it is very much appreciated.I am automating some simple tasks for controlling port access for certain users of our network. The commands that I am going to be se...
Good day, all. I am still pretty much a Cisco rookie and am trying to automate a task. I've been looking at Powershell, Plink and other options.We have a series of Cisco CBS350 switches trunked together with a primary switch acting as a layer 3 route...
Once again, Paul. You have been quite helpful.
These statements that you mentioned were added by web interface wizards and have been removed. Sometimes newbies are at the mercy of a GUI until we know better.
@paul driver wrote:
Lastly looking at yo...
Most certainly.The ACL
Deny_Firewall_Access
is in the configuration but not being used at the moment.
cisco-c1111-8p-01#show ip access-listsExtended IP access list CISCO-CWA-URL-REDIRECT-ACL100 deny udp any any eq domain101 deny tcp any any eq domai...
Work gets in the way of some projects, hence the delay in responding. Busy week on many other projects so I am trying to pick back up where I was at last time. So, here is what got me mostly running... Enough to make my things run properly...
We are ...
Many thanks for the response, Paul.in response to your first question, our new C1111-8p is now doing all of our interVLAN routing and our primary CBS350 switch is back to simple layer 2 switching. We run a somewhat unique isolated test environment co...
