Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I got one problem with cisco ACE in my company. Currently, two ACE appliances are working as HA redundancy. Previously I enabled some https and http probing using get 302 for some servers and services. But then I was told to remove all https o...
Hi,I want to ask if the ACS accounting can be used to log any changes made in web base configurations like ASDM / PDM (for FWSM and ASA) and ACE web GUI. As I know that ACS accounting can log all the change made in CLI.Warm Regards,Charles Chia
Hi,I have a problem in configuring two pair of backup interface on my customer's router (3845). It's ok when I configure just one of them. If I configure both pairs of interfaces into backup interface, one of them will be in disabled mode, as shown b...
Hi,I have problem in my first POC of WAAS mobile today. I just installed the application the same as the document said. I started IIS service first and verified that service run before I installed WAAS mobile. After the installation done, I check tha...
Hi all,I just want to ask if ASA can perform like lock & key like router's IOS security feature???The point is I want to put ASA as the access control between 2 internal departments. I want the ASA to be transparent so there's no hop and no NAT betwe...
Hi Daniel,I just corrected the cert problem and made the state peer into standby hot. But still it still keep probing the get 302. And then I tried to restart both ACEs. The first step is to restart the second ACE (standby) and then switched over all...
Hi ken,It's wierd that it's now in healthy state without me doing anything. I'm going to do testing if it's working well or not. Below is the info for you.1. There is 1 type of error in system :Event Type: ErrorEvent Source: DCOMEvent Category:...
Hi PK,When u said that the ASA proxy will match the traffic on ACL defined in matched statement, it then will be authenticated. The acl before is only just used for triggering the authentication right? and after the authentication is successful, ASA ...
Hi Eric, There's no network flapping issue at all. I just found that the WAAS on those sites having the same minor alarm severity information : "The TFO accelerator is overloaded (connection limit)"Is there any other workaround than just restarting o...
I've already cleared the counters several times and it still shows increasing number on the unknown protocol drops. It even show up in the LAN interface. The LAN itself is simple. Is there any document that can give justification of what can make the...
