Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Community Members,I am experiencing a problem with my Cisco 3602 AP, which is continuously rebooting. It appears that the IOS image is corrupted. I would like to interrupt the boot sequence and enter ROMMON mode to delete the problematic image a...
Dear All,Greetings,I am recently facing this problem my two 1852 APs are unable to join with controller. They were working fine for last six months but suddenly they are unable to join the controller. Below are given complete boot up process output...
Dear Marce 1000,Thank you for your support. The issue has been resolved by following step8. The problem was actually with the mode button—it wasn't being pressedproperly. I opened the back cover of the AP, pressed the button correctly,and successfull...
Thank you very much for your efforts and dedication. Actually, our two APs have been faulty for the same reasons recently one by one and about 10 APs are working in the network. That is why I wanted to make sure the AP hardware problem and you expla...
Thanks alot for your response. I really appreciate it. I find one thing in the output of the AP show ip interface brief output is given below, APA0F8.49E4.2010#sh ip int brief
Interface IP-Address Method Status Protocol Spe...
As in outuput of show version of AP one radio is showing, 2 Gigabit Ethernet interfaces1 802.11 Radios if one radio is faulty but 2nd one is available, what do you think does it should work? or we assume the complete hardware faulty of device?
Thanks,Noted. We will buy new APs. We do not have RMA against these APs now. Could you please elaborate which things in logs are mentioning that the device has been faulty?
