Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Cisco ACE 4710 and I would like to know if it would be possible to forward the following URLS to different backend server ports https://test.mydomain.com/123 --> forwarded to 192.168.1.80 on port 8000https://test.mydomain.com --> forward t...
OKay apologies in advance for this question but I am unable to find a definitive answer anywhere..I understand that Hubs are half duplex, but I cant figure out why? Some people say its because clients use the same wires to send and recieve, but this ...
I the documents I am reading on Cisco.com it says that switches running VTP server mode store their VLAN information in NVRAM, however in reality I am finding that it is stored in flash, in the VLAN.dat file..
From Cisco.comActive Timer: This timer is used to monitor the active router. This timer starts any time an active router receives a hello packet. This timer expires in accordance with the hold time value that i...
Okay with that said then, if you only have two devices connected to a hub can they operate in full duplex mode? because seperate wires are used for tx/rx?
http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_52_se/configuration/guide/swvtp.htmlNote In VTP server mode, VLAN configurations are saved in NVRAM. If the switch detects a failure while writing a configuration to NV...
