Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I've got a Cisco 9800-40 WLC with software 17.6.5I've also got a WLC 5520 with software 8.10.151If I try to move a 9210 from the 9800 to the 5520 the AP doesn't move, even after I change the controller on the HA tab and reload the AP.Although ...
Hi all,Having just upgraded my ASA to version 9.18, I'm now no longer able to ping the inside interface through the VPN.From the ASA I can no longer ping inside (then my internal network)On version 9.16 this was fine.The management inteface is still ...
Hi all,I have a WLC5520 with a few hundred APs on.I want to change the high availability tab details for about 200 of them.For the life of me I cannot find a way to do this in one hit.Is there a way to select multiple APs to do this?Many thanks.James
Evening all!Something is bugging me because I cannot find a solution to my problem.I have a switch template that I put together which includes SNMP v3 config.The issue I've got is that I want to have in the template, the encrypted SNMP v3 credentials...
Hi All,Scenario:-I have set-up VSS on two 6800s and it works just fine.I've read the design guide and best practices etc and added a couple of lines on switch 2 to delay the ports from coming up for 300 seconds.This is all fine and well but consideri...
When I say, manually change the image, I mean SSH to the AP, and change the boot path - then it works fine.This is unusual and this isn't the first time I've moved APs but they seem to get stuck moving across on their own.I can wait for ages and noth...
Thanks for the info.After more digging it seems it's been fixed, or more of a proper workaround in 9.18.In 9.18 you can have loopbacks and they're compatible with SNMP etc, so that's what I'm going to do.Cisco do make some bad decisions these days. ...
