Hi All,
Do we need the ISE and the DNA center to be implemented on the same site? or we just need to grant connectivity between them?
is there any other requirements for this integration?
Many Thanks,
Hi All,
For Cat 9K switches used as Border and control nodes in an SDA setup. do we need to have a specific physical interface on the switch for control plane or we can provision all physical ports(interfaces) as a control plane port.
Many Thanks...
Hi all, i want to add the available memory of my ASR 9912 to the PRTG and i am facing a problem where the PRTG is reading or showing wrong integer. (that was by add cisco system health check sensor). Any idea how can i add a sensor (can be custom) to...
in other words, between the Fabric Edge nodes and the Fabric border and control plane do we need two interfaces, one interface for control plane and the other for Data Plane. or is it on the same interface?
Hi fcuiller,
it is a very helpful guide.
as i was checking the products that can supports cisco optical routed network, i noticed that NCS 4000 series doesn't support RON. why? is it just used for OTN switching? and DWDM/OTN integration?
Thank yo...
Hi,
Correct if i'm wrong.
Routed Optical Routing took place after the introduction silicon technology, which led to replace some DWDM components such as Transponder cards, RoadM cards that were usually deployed in the NCS chassis into a pluggable...
