Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, Very new here and with ASA's, so bare with me. I followed some videos, and got to the point where I get a successful AnyConnect VPN Tunnel however I cannot ping anything on the network. The local network is 10.10.10.0/24 and the AnyConnect...
Hello all, Bear with me, as I am VERY new to Firewalls, just messing around with a old ASA5520 in my lab. I am trying to set up the firewall so my Avaya IP Phone can VPN Back to it. Here is where its getting stuck: The only Phase 2 settings I can inp...
Hello all,Very new here and to Cisco, so I apologize if this is not the correct spot to post.So I am a ACSS Certified Avaya Engineer and I am looking to get more into Networking.I have an older 5520 ASA that I was able to Factory Default and load the...
@Rob Ingram I ran the commands you mentioned: object network RAVPN subnet 10.10.30.0 255.255.255.0object network LAN subnet 10.10.10.0 255.255.255.0nat (INSIDE,OUTSIDE) source static LAN LAN destination static RAVPN RAVPN no-proxy-arpobject network R...
I just wanted to add, including this line in the ASA allowed me to remove the IP Route in the PBX routing from the VPN DHCP Server Pool (10.10.20.0/24) to the PBX (10.10.10.0/24)access-list nonat extended permit ip 10.10.10.0 255.255.255.0 10.10.20.0...
Hello all, I just wait to say thank you for all the help, I got everything working. I am also quite impressed with myself, being this is the first Firewall I have ever touched and it did not take too long. Have a great weekend everyone!
