Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a site that just installed a Copper Industries SP40s paging system. (See link below)http://www.cooperindustries.com/content/dam/public/safety/notification/Resources/Instruction%20Sheets/P84714.pdfThe information provided by the vendor is:we n...
Greetings,We are trying to install CIPC 8.6.2 using MSI using the below.msiexec /i CiscoIPCommunicatorSetup.msi TFTP1=172.17.1.2 TFTP2=172.17.1.3 FREEFORMDEVICENAME=%extension% /qb- reboot=reallysuppressThe installer isn't creating the TFTP values in...
Greetings,We have a a requirement from the business that when phones are not registered that they continue to ring since there is no voicemail setup for this site (they don't to hear the fast busy) The only setting I see for unregistered phones is to...
We have 2 T1's bundled in Mu1. The Mu1 interface is showing input, frame, and overrun errors, however the serial interfaces do not show any errors. I know there is a bug out there there that is close, however this is supposed to be fixed in our versi...
Greetings,I have an ATA 186 (sccp) that was plugged into a switchport that just had a data vlan and no option 150 configured. Now the ATA is plugged into a switchport with a known good voice vlan ( a brand new ata was plugged into and pulled an ip f...
Thanks Mark,I was able to upgrade the image on this manually ATA and it now pulls the correct IP/Voice VLAN. However, it still does not register with the UCM. As I said before this is a known good port since I have plugged in new ATA's and the pull t...
