Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have several CW9178 access points, and one of them (let's name it AP3-01), has suddenly stopped working on VLAN 20. Clients that connect to the SSID tagged with VLAN 20 cannot get an IP address and cannot send or receive any traffic. In the ...
Hello Expert,I am looking for a template configuration for a zone based firewall to be applied on ISR 4300 series router. If there is anyone who could share a sample config file for ZBF, that would be very much appreciated. We just need a config that...
Hello Experts,Problem: need to connect to ISP line which uses IPoE (IPv4 over IPv6) protocol with MAP-E method.ONU <--->(G0/0/0) Cisco ISR 4000 router G(0/0/1)<---> Firewall <---> LAN client devicesHere, the firewall provides NAT translation to all L...
Hi Experts,I am having a weird issue with Catalyst c1000 switch and Aironet3802 APs. This afternoon someone at our workplace brought in three microwaves in a one room and operated them simultaneously. It overloaded the circuits in the room, and as a ...
Hi,On our Meraki MDM dashboard we see a number of old devices that are physically inaccessible anymore.We tried deleting them multiple times but they show up again after few days. Then we tried method described here https://documentation.meraki.com/S...
Plugged in the same model Meraki CW9178i, but different access point to the same switch, same port. All works fine. But this particular AP is still not working with VLAN 20. Clients connect to it then immediately disassociate on VLAN 20. However, on ...
Wow, that is very useful information. BIG thanks Leo! It is much appreciated.The problem AP has been restarted multiple times, reset full factory default twice. Still VLAN 20 is not passing, whereas VLAN 60 works perfectly on the same AP. I have run ...
Hi,Thank you very much for your reply. All other access points connected to the same switch are working fine, therefore it is certain that uplink is passing VLAN 20 traffic without problem. Also, I connected a different AP to the same port that was o...
Hi Balaji,Thank you so much for taking time to answer my question. My apologies if I did not provide sufficient details to the problem description.1. Internally we would like to use IPv4. It is just our new ISP line requires IPoE (IPv4 over IPv6) pr...
Hello Experts,Many thanks for your advice on to troubleshoot the issue. Special thanks to Mr. David Ritter. After inspecting the AP logs, it was identified that the WLC 5508 certification has expired. I did temporary workaround by resetting its syste...
