Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have two VSS clusters interconnected via a trunk allowing two VLANs.Both VSS clusters have an SVI for both VLANs.Problem is that I cannot ping the IP address of SVI cluster number one from number two and vice & versa.However I can ping a PC con...
Hi all,Small question about load-balancing TACACS+ server:In the ACE IOS, there is a preconfigured probe for RADIUS servers, however there isn't any for TACACS+ server.Does anyone have a TCL script to check the TACACS+ service?Note: if you configure ...
Hello!We have Application Networking Manager 3.1 running. The problem is that the time reported by ANM is not in the correct time zone.I guess that it was configured during the ANM installation (I did not install it). Is it possible to change it ?Not...
Hi Folks,Same issue here.Other interesting post:For info, here are Bugs I found related to DHCP:CSCvs03177 : Client stuck in IP learn state with FlexConnect local switching + central DHCP + DHCP required.CSCvr86358: Cat9800 sourcing DHCP proxy packet...
Hi RenanThank you for your reply.Actually, Each VSS cluster has already been configured with "mac-address use-virtual".I don't think it is related to VSS setup, the problem is that VSS clusters cannot talk to each other because they use the same Mac ...
Hi Lucien,Thank you for this answer.The list provided in the Prerequisites section of the "Cisco Wireless Control System Configuration Guide" (release 7.0, pg 2-1)is not exaclty the same:- HTTP: configurable during install (80 by default)–HTTPS: conf...
Hi there!Would you recommend to add "BPUDguard" along with porftast on the trunk in order to put the port in error-disabled state in case of BPDU received on the trunk?Regards,LLP
