Dear all,
a customer use 8.0.140.0 on a WLC 5508, currently the 1240 APs get the 12.4(25e)JAM5 image, because of a Bug the APs will need 12.4(25e)JAP10 or JAP4.
Is it possible to Update the AP Images on the WLC? Does Cisco update the WLC Images wit...
Working from home is great, but it creates noise that doesn't normally occur in an office. Vacuum cleaner, family, workers and so on. Cisco noise removal helps improve the conversation in a meeting.I'm glad Cisco has been adding more features to Webe...
Th short version is:1. Backup current ISE2. Install a new VM in Version 2.4 / .6 + patch3. Restore Backup with ADE-OS4. Change IP or setup a second interface to check config5. Shut old ISE VM network interface6. Enable new ISE VM network interface wi...
Just a quick response on that topic. In the meentime I replaces a ISE 2.3 in a productive SD-Access Network by installing a new ISE 2.4 and restore the backup from 2.3. Switching to new ISE was no problem at all. Just disabled the old ISE VM Network ...
Hi Arne, that sounds like you may figure out a good way to migrate the ISE in a DNAC. Espacially the you first point (place-holder AAA) is very interessting. I tried this as well and it didnt work, I may have to try it again in my lab. Which DNAC ver...
Hi Arne,Im still in contact with Tac/BU about that.I tested a backup/restore upgrade in my DNA Lab. So, taking a backup of e.g. ISE 2.3 and restore it to a 2.4 is working well as long as the fqdn and ip are the same.regardsMatthias
.jpg "VIP Advisor"){kind=icon}
