Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have ASA configured for internet traffic to default route to 0.0.0.0 0.0.0.0 x.x.x.x . I created a vpn tunnel with cloud services named BlueCoat so they can manage our internet traffic. for testing purposes I need to create a lab and forward one ...
Hello everyone,I am trying to setup Nexus 1000V VSM and VEM. My ESXi host has four network ports. For management I am using only one of the ports on the quad nic card as a trunk. It is trunked to Cisco 3750 switch. Another one of the quad nic card...
We are in the process of implementing DMVPN hub and spoke solution. We have configured a hub and are now trying to connect a remote spoke between client’s remote locations. The client has a Verizon router in front of the spoke. Somehow I am not ab...
Could you confirm that jumbo MTU setting is enabled on your switches? Run the following command this will show you if jumbo frame is allowed
show queuing interface eth 1/1
or use the following link.
http://routing-bits.com/2011/04/05/jumbo-mtu-on-ne...
Thanks Shankar for your response. I figured it out. It was port-channel configuration issue. I had connected the uplink directly into vlan 2. I should have added that interface into port-channel. Thanks again.
No I am getting spoke external interface ip from verison modem+router . Which is 192.168.1.X. I put this ip address to the DMZ zone that won't fix the problem either.
