Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I am migrating ACS from 4.2 to 5.8 and in this i am facing challenge in defining command sets as per my need.
What i want is simply allow ping command with allowed arguments as below
1. size from 0-1500
2. repeat/count 1000 max
I am having a hard ...
Hi,
I am configuring command sets in ACS 5.8.
I need to know how to allow all arguments for a specific command
e.g i want a user to configure a vlan on IOS device and its subsequent configuration options.
What i can see is i have to allow comman...
Hi,
I am configuring cisco ACS 5.8 and want to allow some specific command in command set while blocking its related commands.
for e.g
permit ping .* size 1000
permit ping .* count 500
I just want to allow above two argements with mentioned values...
Hi All,
I have been seeing lots of BGP Peer flap alerts on my ASR9010. And often this syslog is observed
%ROUTING-BGP-3-NBR_NSR_DISABLED : NSR disabled on neighbor x.x.x.x due to 'ip-tcp' detected the 'warning' condition 'NSR is down because the re...
Hi Gagan,
its not working with blank argument.
Switch(config)#vlan 2002Switch(config-vlan)#namSwitch(config-vlan)#name TESTCommand authorization failed.
Switch(config-vlan)#
Vlan get created but cant go under vlan.
config-commands are already al...
Hi Xander,
Thanks for the explanation. I would definitely open an SR with tac. Meanwhile, i would just like to know that if both RPs are not synched with each other over some BGP peer it wont effect actual BGP session?
What i understand is that NSR ...
Hi,
I have noticed you have all the packages activated on your chassis, do you need all of them?
Is it not a good practice to have all the packages activated whether you are using them or not. They certainly occupy memory, try to deactivate and remo...
Hi Masood
Can you inform which MIBs or OIDs are you polling for CPU and Mem? Have you tried polling from a different NMS and see do you get same results or not.
Hi,
ASR9k when surpasses memory levels such as yours "severe" it will try to recover the memory. BGP being at the top of memory eater in protocols. You can check memory thresholds you have on your box via "sh watch thresh mem conf loc all" and curren...
