Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am new to Cisco meraki dashboard and it's functionality.I have set-up WiFi Guest network, where Im useing access control metod via Sponsored Guest login with OWE.Everything is working fine, devices are able to join the network, once someone c...
Hello,I am still considering wheter to deploy Catalyst1000 or CBS350 switch at our small office(15-25 devices).Switch have to be configured with multiple SVIs and DHCP server pools for each + few static routes.I would like to secure MGMT access to th...
Hello,I need your help I have run into a problem I Can't get over.I have got two separated companies under tho roof which are useing separated L3 subnets, but same VoIP MPLS vlan-subnet,which is just switched over each company-distribution switch dir...
Hello I'm planing to perform firmware upgrade of our C9200L switches, including:One stacked (StackWise) switch, consisting of two C9200L-48T-4X (Active/Standby) , acting as Distribution switch.- Currently on 16.11.1 CAT9K_LITE_IOSXE , INSTALL mode 6...
Dear All, I'm little bit practicing in packet tracer and I went into one uncertainty about HSRP.Let's imagine you have configured SVI for Vlan10, on two Multiplayer-switches [A, B], interconnected between each other, via two trunks.HSRP active is Swi...
Actually, Im configurting my Catalyst 1000 and I'm surprised !It is possible to configure ACL for: VTY line access, snmp-server community, quiet-mode.
Would do you think about another possibility, that I would reconfigure both site for Rapid PVST.I guess every Vlan would have it's own STP tree, so for most of the Vlans elected Rood bridge would be the site's Distribution switch.And only for VoIP-MP...
If it's just caused by virtual appliance of Packet Tracer Environment, i would be enough satisfied.I just wanted to make me sure that this couldn't happen in real environment. Funny thing is that, once I re-enabled SVI, I noticed a message:%HSRP-6-ST...
