08-14-2023 01:01 AM
Hello
I'm planing to perform firmware upgrade of our C9200L switches, including:
One stacked (StackWise) switch, consisting of two C9200L-48T-4X (Active/Standby) , acting as Distribution switch.
- Currently on 16.11.1 CAT9K_LITE_IOSXE , INSTALL mode
6x standalone C9200L-48P-4X, one per each floor, acting as access switches.
- most of then are on versions 16.9.4, 16.9.07, in BUNDLE mode
I would like to kindly ask you, for your advice, which version should I choose in this scenario.
I was considering cat9k_lite_iosxe.17.06.05.SPA.
But to be honest, I didn't went through opened TAC cases or announced problem in particular versions, so I would really appreciate your experienced advice.
Also any of your advice about stack upgrade/ installation process I would highly appreciate, since I'm going to upgrade stack for a very first time.
Thank you very much.
Solved! Go to Solution.
08-14-2023 01:12 AM - edited 08-14-2023 01:17 AM
Hello @kralopafo,
17.06.05 is a suggested IOS version for your C9200.
The other suggested IOS is 17.09.03.
See here: https://software.cisco.com/download/home/286320181/type/282046477/release/Cupertino-17.9.3
Please find here the release note, check your version 17.06.05:
Find here official documentation for stacking your model with this Firmware version:
08-14-2023 01:07 AM
Go with 17.9.4.
08-14-2023 01:12 AM - edited 08-14-2023 01:17 AM
Hello @kralopafo,
17.06.05 is a suggested IOS version for your C9200.
The other suggested IOS is 17.09.03.
See here: https://software.cisco.com/download/home/286320181/type/282046477/release/Cupertino-17.9.3
Please find here the release note, check your version 17.06.05:
Find here official documentation for stacking your model with this Firmware version:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide