Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
What is the CLI (or ASDM) config on version 8.2(5) to configure the NAT bellow (it is in the version 9.1(6))?
nat (outside,outside) source static OBJ-10.30.100.3 OBJ-10.1.252.10 destination static OBJ-10.200.200.219 OBJ-172.31.18.219
The flow...
I have two Cisco ASA 5520 and I am not able to perform Failover because one peer have a base license and the other have a license with additional Security Contexts. I need to have a match with the Security Context and it is not a problem if I need to...
I have 2 Nexus 5548 connected by 2 links using SFP-10G-LR Gbics. All the ports are in protocol down state. I`ve already tested the cabling between the DCs - it is monomode and OK. Does anybody knows if it could be a N5K configuration parameter, softw...
Hello,Is there a way to identify if a switch port is burned via CLI?I have a 2960-48PST switch and some ports don't provide power to a PoE device connected. When I change the port, the device turns on.
Thank you Dosztal,So the difference is just on the products supported?I Have some 3750 switches and I am looking for enabling power redundance in them.According the Cisco Documentation 3750 platform supports the both products."Q. Do the Cisco Catalys...
