Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,Can someone tell me if there is a way to clear out old voice routing?My situation is that we have bought a refurbished AS5400 and have an IP trunk to a Cisco call manager that is forwarding a test number.With just an IP and routing on ...
Hey all,I have a question since I have not done voice for a while. Is there a way to register a Cisco 7940G to an Avaya S8700 that is running H323 and not SIP?If so please send me whatever you have.Thank you,Ken
Hey all,I have not programmed voice in years and I am programming an AS5400 as PRI.I setup the primary D channel just fine but when I try to do the backup D channel it gives me this error:CCT_ATT_SE_VOICE#conf tEnter configuration commands, one per l...
Hi,I have a Cisco WLC 2112 and I am trying to set it up to pull the DHCP addresses from my DMZ on my firewall. Does anyone know of or have a simple config to get this up and running?Thank you.
I need a hand on getting a P2P T1 up and running. I have an up/down link. I am using static routes and have tried using bgp but nothing is bringing the link up.Serial0/1/0 is up, line protocol is down Hardware is GT96K with integrated T1 CSU/DSU D...
Also, do you know where to change the bearer capability on the AS5400?The test calls are failing due to the bearer capability being set to data.Thanks,
That is what I though as well but there is no line code under the individual controllers:CCT_ATT_SE_VOICE(config)#controller T1 7/0:1CCT_ATT_SE_VOICE(config-controller)#?Controller configuration commands: cas-custom cas group customization confi...
One last question when I look at my T3 controller it says the line code is B3ZS and I need it to be B8ZS. Do you know how I change this, it is not under the controller itself.
