Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We currently have an existing 3945 doing BGP with our ISP. We'd like to put in a second router and utilise HSRP on our internal side to improve redundancy. Our ISP has suggested we do separate BGP peering sessions on the 2 routers towards them and us...
Hi,We have a Cisco 1522AG configured as a MAP in our production network. Last week the AP went down. On investigating it keeps rebooting itself. constantly showing 4 orange leds, Maybe cant find the WLC? Is there a way to console into these devices t...
Hi,We just bought a new 6509-E with 4000w P/S. The specs say it requires a 23 A/240V Input is this the max input current permissible? We have an existing 6KVA UPS with output of 16A max. I've used the Cisco Power Calculator and with all the current c...
Thanks for that. One more thing is there a way to factory reset the Mesh APs. Tried through the console but no luck there as the AP keeps rebooting itself after failing to assiociate to an RAP.
I've tested it out and it works. Switchover takes approx 180 sec due to the holdtimers of BGP. If I were to modify this what would be a suggested value? 10sec Hello 30sec Holddown. Are there any side effects to lowering these values?
Thanks Rares, I did see in the documentation a RJ45 port in the section for connecting up a fibre to the AP but the docs did not say what was the RJ45 port. I'll try this out.thksTerry
