Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anybody know if it is possible to do syslog logging on a per port basis? This is to avoid getting the "%LINK-4-ERROR: ... is experiencing errors" messages on certain ports where customers set the duplex incorrectly. "no logging event link-status...
Any ideas why a 6509 Native IOS 12.1(20)E2 WS-X6416-GBIC module powered down causes the supervisor and system to freeze when removed. Does Native IOS not support OIR?These are the syslog message generated.---%C6KERRDETECT-SP-4-SWBUSSTALL: The switchi...
Does anyone know the Native IOS command to shutdown a 6509 module. In other words the equivalent of the CatOS 'set module shutdown <n>' command. I am specifically interested in shutting down a WS-X6416-GBIC module.ThanksMatt
Does anybody know if it is possible to upgrade the onboard flash (bootflash) on a Catalyst 6509 SUP2/MSFC2 shipped with 16MB. This is so that the native ios can be booted from bootflash.If this is possible are there are documents detailing the proced...
Does anyone know if there is any documentation to interpret the output of 'debug atm errors'I am specifically interested in bad sap messages on IOS 12.2(8)T10.The standard ios documentation link contains only how to turn this command on and off.
Obviously it can be done with two object groups and two access-list entries but the question was, can it be done with one. I guess the answer is NO unless someone else knows better.
Has anybody actually got this to work? I have a USR modem which works perfectly well on a 3600 aux port for remote dial-in but not when plugged into a pix (515) console port with the same cable. It looks like the pix is expecting the modem to be setu...
