Hi,
I have 2 routers connected together
1rst router is nominal => Cisco 1841, "flash:c1841-spservicesk9-mz.124-15.T12", Version 12.4(15)T12
2nd router is used as backup=> CISCO881-K9, c880data-universalk9-mz.150-1.M4.3,
Netflow is implemented o...
Hi,
I have a esx connected on nexus N2K-B22HP-P on port eth106/1/1, and i have TX output error which increase a little bit, is it normal ?
I have not counters errors.
# sh int eth106/1/1 | in CRC|DROP|discard|error 0 runts 0 giants 0 CRC 0 no buff...
Hello,
Equipement: CISCO2921/K9
Cisco 22921 is used as Customer Edge
I have one interface g0/0 which is configured with subinterfaces (g0/0.200, g0/300).
g0/0 haven't IP adress but each subinterface have IP address.
interface GigabitEthernet0/0 no ...
