Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our current environment consists of two core switches supporting 10 access switches, a firewall, and a DDI server. We are running VLAN SVIs with HSRP for redundancy. Each core is connected to a separate SD-WAN router with OSPF running between them. W...
I have a router and both isp link down and now router is unreasonable and wanted console but is it possible we can configure it via console as isp needs to change wan ip.
In my environment the control connection between vsmart and c-edge is showing down, handshake sate. With control connection with vm and vb is fine, also no packet drop or issue in isp link as all bfd session like 233 are showing up only control conne...
We are going to configure the callhome on Cisco nxos switches and want some assistance for the configuration.I read some artical but could not if anyone have any live device config just share with hiding any official config
I have some user connected on 'abc' ssid and it's configured with security features WAPA2 +WAP3 with disabled fast transition mode. Earlier user was connected but after some days user disconnected and unable to connect with wlc so when we enabled the...
But we are not wanted the chaos during migration and have less implementation window, so we are trying to migrate it veriy short duration and prepare the plan
Hi All,Thank you for sharing the details and for your time.I just convert the c-edge device mode from vManage to cli and have done the needful.Thank you again!
