Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have an environment where roughly 800 client PC without LDAP/AD are integrated. The user just login into the PC using the local Windows credential. With this kind of environment, what can I achieve/benefit from if I were to integrate Cisco ISE ...
Hi,I have a cisco 9300 multigig poe switch where I use to connect to AP. The AP model i have is 3702I, all my AP connected to the switchport have high input error as seen below: TenGigabitEthernet1/0/10 is up, line protocol is up (connected)Hardware ...
Hi, I am trying to install DNAC but encountered the below error during the initial configuration:What could be the possible cause? === stderr ===Can't open file /etc/maglev/.pki/passphrase.txtError getting password140580132876736:error:02001002:syst...
Hi BB,Is that mean no matter how I need to implement some sort of enterprise authentication method instead of normal local Window login at the client PC in order to get the full benefit of Cisco ISE? regards
Hi, Below are the Wireless -> Access Points -> Global Configuration -> Global TCP Adjust MSS setting:But I still do not understand why the AP interface BVI comes with the default MTU of 1792? I can't change the value nor delete it via CLI.Manually s...
Hi,It happens to all switch interfaces connected to the AP. After further investigation, the AP interface BVI1 by default has MTU of 1792. interface BVI1mtu 1792ip address x.x.x.x x.x.x.x GigabitEthernet0 is up, line protocol is upHardware is PowerPC...
