Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone! I hope all of you are doing great and would like to thank anyone in advance for taking their time to read this. I am sure that I am not the only one that has experienced this. I did find a couple of posts on these forums with the same...
Hello Everyone, I have a Cisco 2960 that I want to set to local access only. So ultimately the switch can only be logged into with an account that only exists on said switch. I went through what I thought were the correct configurations however, it d...
Hello All, I apologize but I was not able to locate any documentation on this specific setup and my efforts have not yielded any fruit thus far. Thank you in advance for anyone that is able/willing to assist. Scenario and Objective:We have a 48 port ...
@Rich R @Leo Laohoo @Arshad Safrulla @Haydn Andrews @Scott Fella All, this appears to have solved it! I thank everyone for chimming in and giving some much needed compass bearings. I think we had a couple of different issues going on here. The AP be...
Arshadsaf, OK I see what you were saying with the second part of your response now. I tried accessing the AP several times but everytime I see the login prompt, it gets drowned out with random outputs. I am not able to actually login anymore. The fir...
Hi Haydn et al, sorry it took so long to get back. Finally had time to check up on this. The output of the command asked to run shows some very enlightening thing. I think it does have an IP address but the WLC is just straight up rejecting it. Any t...
Haydn, I have confirmed that the switch pulls the correct MAC address. The sticker is right on this one Is the connected switch seeing the AP as a CDP neighbour? No it is not. Which is strange since the AP's MAC is registered in the MAC table of th...
Hey Scott, thanks for the info. OK, I am not sure why this setting was disabled on our end. Perhaps my predecessor enabled it to allow the other external AP to join and then disabled it to prevent what you are describing with the reboots. I'll roll t...
