Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i made a pvlan configuration, anyway its seems to be not working. VLAN Config on Core: vlan 2500
private-vlan primary
private-vlan association 2600
vlan 2600
private-vlan isolated Access Port Config for PC interface GigabitEthernet1/0/36...
Hi,
have a problem with
C1111-4P.
Installed with
17.11.1a
All RSA Keys are min 2048 bits strong. Anyway, also
crypto
engine complience shield disabled.
But after all reload SSH, and
http secure-server
doesnt works anymore, i need to
zeroize
all keys ...
Hallo,
since ios upgraded to
17.11 on C1111
router, i continously receive
syslog
error messages:
RSA keypair HTTPS_SS_CERT_KEYPAIR
is in violation of Cisco security compliance guidelines and will be rejected.
How can i delte and re-generate this keyp...
Hi, i bought a 9200cx layer3 switch. It comes with network-essentials license built in, perptual license.As soon i connect it with my smart account, it says: network-essential license count: 0, in use: 1, balance: -1Why? How can i attach the built-in...
Hi, i have a C9120axe Access Point, with factory installed EWC software as default. I would use it as Normal AP with an 9800 WLC. Therefor: how can i remowe completly the EWC Software from the device? (not only to tun in capwap mode)Thanks
ill do it then with console cable. After
zeroize
and re-generating
rsa
keys, and register
snmp
user again, works well, but only until the next reload. (or power loss, etc...)
