Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3750G that has been reset to factory default and very basic setup done so far Port 24 is set as no switchport and connected to my ISP router. I have so far set this port up as DHCP and gets IP address from the ISP router. From the switch I c...
We are currently replacing all our AP's with Meraki MR56, therefore I want to use the 2702I at home They are currently setup in lightweight mode and connect to a WLC - I have read many articles on setting them up as autonomous mode but get different ...
I have managed to aquire a 2951 router so will be replacing my ISP router with this one so will be fully Cisco kit at home from 2960 and 3750 switches to 2702I AP's Will configure the 2951 as a DHCP server As per your other comment, port G1/0/24 on t...
I resolved the issue, as stated this is a L3 switch and can not do any NAT, so renabled the port 24 to a normal port and this then worked and laptop got IP from main router.
lt sorted now did notioe when I tried to create another SSID on Radio 0 it did not allow me to do this what command do I use to allow me to have 2 SSID On Radio 0
