AIR CAP2702I-E-K9 to Autonomous Mode

[AxL1971]

We are currently replacing all our AP's with Meraki MR56, therefore I want to use the 2702I at home

They are currently setup in lightweight mode and connect to a WLC - I have read many articles on setting them up as autonomous mode but get different methods

I have access to the USB console cable so will use the CLI method

What is the trusted method to convert these.

Initially I want to clear current settings then flash the autonomouse firmware

[marce1000]

   - What do you mean by 'trusted method' ?

 M.

[Arshad Safrulla]

Below are some goof articles which explains the conversion process

https://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

https://www.speaknetworks.com/converting-cisco-wireless-access-point-lightweight-mode-autonomous-mode-vice-versa/

You need to download the Cisco Autonous AP image from Cisco in-order to convert it.

Software Download - Cisco Systems

[AxL1971]

lt sorted now 

did notioe when I tried to create another SSID on Radio 0 it did not allow me to do this

what command do I use to allow me to have 2 SSID On Radio 0

[marce1000]

 - Following GUI and or creating multiple SSID's/WLAN's should work. What error do you get ?. And or post screenshot (e.g.)

 M.

[Arshad Safrulla]

Follow the below guide

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3/cg15-3-3-chap7-mbssid.html