Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening,I'm faily new to networking so bare with me. Tonight, I created an uplink coming from an HP procurve switch to my Cisco 9300. The trunk port is UP and I can view my cameras on the VLAN, but I'm seeing a weird flapping in the logs of the ...
Good evening,I have 2-9200Ls stacked together in IDF1 closet and 2-9200Ls stacked together in IDF2 closet. I recently had something happen at the same time last week and I lost 140 ports for approx. 5 minutes. My cameras on the active and standby sw...
I'm fairly new to networking and will try to explain my situation. I have a Cisco Network which consist of a 2 stacked 9500s in my MDF, 3 stacked 9200Ls in the same MDF and a couple other IDF closets each having two stacked 9200Ls. I also have a full...
I having an issue with accessing the webui for the catalyst 9200L. My previous vendor configured my switch. I can access the switch through putty but have limited education with CLI and would prefer to use the webui. I can access the webui Cisco cred...
I posted the show tech in the comments below. Thank you for your question, please let me know if the show tech command didn't show you what you were looking for and I will try to go back to the switch and get more outputs.
Speeds appear to be 100/1000T. The HP switch works fine when only using the uplink ports. Anytime I connected more than 2 cameras to the HP access ports, the port flapping starts. I ended up powering the cameras via POE with a Cisco 220 switch and up...
The 2 switches are connected via SFP ports using single mode patch cable. All SFPs and patch cables are brand new. The switch works fine when using only the Uplinks. Anytime I connect more than 2 cameras to the access ports with POE, the port flappin...
Thank you for your replies. I will post the putty log with the show tech output. =~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2025.01.08 13:20:19 =~=~=~=~=~=~=~=~=~=~=~=[2J[?7l[3;23r[?6l[1;1H[?25l[1;1HProCurve J9299A Switch 2520G-24-PoESoftware revision J.14.01...
