Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,has another done this set up before.router 2600 (aux) ----> modem --4 wire (lease line) ---->modem---> router 2600 (aux).kindly advise what is require to take note to set this up.i have followed thru the configuration provided from cisco website. ...
Can i have the router to choose to go via 203.208.174.18 instead of 203.208.174.22?AMSTRM-7206VXR#sh ip route 203.208.174.18Routing entry for 203.208.174.16/30 Known via "connected", distance 0, metric 0 (connected, via interface) Redistributing vi...
Hi,I am trying to configure a spam port using a 2950 switch. eg. PC1 send a packet to PC2. I want PC3 to get a copy as well.I understand that spam port is able to do the job. My question is --- can PC3 still allow normal TCP/IP operation. eg allow ot...
Hi,I would like to find out how does my router built up it best path. From the router itself, what command must i type to check on the following attribute in the bgp path selection . Network Next Hop Metric LocPrf Weight Path*>i...
would like to know the following.1) what is the default username and password for the ap1200i need the above information when i click on the setup->ethernet (identification).If there is no default. how do i do a password recovery.Thanks
The zyxel modems support 4wires LL and AA. These can be configured from the modem LCD. The modem back to back has been proved working when i use both PCs as DTE.Is there any debug command that i can try to use on the router to find out what went wron...
Type of modem = pstn modem.i have configured to both line 65 for my 2 2600 routers.Regarding the command show modem log. This command is not found in IOS 12.3(10). Can you help to recommend me an IOS that i can use.
