Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi members,
We faced interface down when trying to enable gi0/0/3 on ASR1002 to interconnect using a cat6 to a Cisco 6500 switch on gi6/1. The interface module used was a GLC-T 1000Base-T SFP(non cisco sfp)
interface GigabitEthernet0/0/3 no ip addre...
Dear Members, I am trying to troubleshoot and revive a crashed router over the weekend.I tried consoling and rebooting the router but nothing appeared on my screen(on a black screen). I suspected it would be an issue with the ROM which must have been...
Dear Members, I would like to find out how we can increase the number of anyconnect vpn logins.Our current license only allows for 2 logins.What can we do to increase the number of anyconnect vpn logins to 10 users at least? I will be looking forwar...
Hi Everyone,I am recently noticing the error log below on our gateway BGP router and am interested to know the fix in order to clear this error log.Jul 22 11:26:47.739: %EARL_NETFLOW-SP-4-TCAM_THRLD: Netflow TCAM threshold exceeded, TCAM Utilization ...
Hi,I was wondering if it is possible to do a global IP to global ip NAT on cisco router.I have a scenario where a LAN has access to 2 Internet Providers(Public networks)And in order to divert some traffics from the LAN that has Provider1 public addre...
Hi experts,
We even tried a Cisco brand SFP but still facing the issue(interface down)
Also need adding that for both non-cisco and cisco sfp there was a critical alarm
Hardware StatusCritical
This was only cleared by disabling the interface for gi0...
Hi Leo, Thankyou for responding!!Yes, appliance is powering up. Yes, I can see LED display.ok, if the appliance's baud rate was changed, how can i recover that?I doubt my console settings were wrong because I could console into other routers and swit...
Hi Akash,Thankyou for this explanation and the fix you have outlined.So far now(more than a week) we have reduced the log buffer from 100000bytes to 8192bytes and after reboot the error seems to have gone away. We are still monitoring this issue and...
