Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As I understand it, the traffic flows at both L2/L3from a VSS node will favour local connectivity to that of its peer and traversing the VSL. This is documented at a high-level in the Whitepaper and software documentation below.
http://www.cisco.com...
I have a requirement to upgrade a a pair of active/passive FWSM's to get around a specific bug: the code is currently 3.1(1) and it's running in a 6509-e SUP-720-3B (12.2.(18)SFX8). In view of the available downloads the Safe Harbor logo seems to hav...
Are Egress and Ingress Filters installed on all border routers to prevent impersonation with spoofed IP addresses?I cant seem to get my head around the logic unless I start to specify criteria such as it must be the spoofed addresses are RFC1918 comp...
Hi,I'm currently seeing an issue on our VPN Conc. the device is running the latest software. We have in the region of 1000 users that connect remotely. However, when monitoring the device via snmp. At no point throughout the day can I get the interfa...
What would the expected behaviour be for a traffic destined for a Vserver on the CSM module if it and then it's failover failed. Will the MSFC module step in and continue routing traffic ? or is a Disaster scenrio ?
Hi Herman,
The difference is simply the image version of code, for example <value>-1712 = 17.12 and <value>-173 = 17.3 and as detailed here : Cisco Catalyst 8300/8200 Series Edge Platforms Ordering Guide - Cisco
If you wish to view the variations be...
Hi,
Check the commands used within the policy-map for priority traffic. The ASR's have a feature that allow priority queues to burst when bandwidth is available. Effectively, you don't get the cold hard police limit that you used to. These can be de...
Hi Martin,
I'm not sure if you had any answers and or came to your own conclusions. In the past few week I've had an opportunity looking at a similar scenario but based around the 6500 architecture. One thing that I have learned is that VSS seemingly...
three minor recommendations:Can you remove the route "ip route 172.16.0.0 255.255.255.0 <>" as this should not be requiredRun a telnet test on 3389 to a server eg: telnet "ip address" 3389 and see if you get a response. This could indicate an MTU bas...
