Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Wanting to ask the great wisdom of this group regarding an port-channel question.Have 2 3750x switches I'm trying to create a port channel between. interface GigabitEthernet1/1/1
switchport trunk encapsulation dot1q
switchport mode trunk
...
Trying to narrow down possibilities for an issue with 2504 WLC and airprint/time capsule. Initially got the WLC unit in and 8.1 loaded. Discovered nobody could use airprint. Ran across a posting about cisco dropping some portion of support for bon...
Wanted to ask about the switch component config for getting bonjour setup on a 2504 WLC.
The guides I have come across so far keep saying that the switch portion needs to have ip pim dense mode configured. But, the switch I have only has ip base i...
Just got a hold of a 2504-5 WLC unit and before it arrives I wanted to do a bit of config work.Currently have 2x 3502e, 1x 3502i, 2x 3602e all set in auto modeThe issue I'm hung up on in setting the dhcp options for multiple vendor classes.but I supp...
If I can ask for some pointers or ideas on this:Currently have a mix of 3502e and 3602e APs. They are configured in auton. mode, so no WLC. The same config across them has a native vlan of 1, vlans 10, 20, and 60. These all are running off a stack...
alrighty, we have success. Got the fiber cables in and I already had the Te ints prepped, removed the copper sfps, inserted the fiber sfps, popped the fiber cable in place and everything came up right away.Thanks again for all the insight!
When I looked at the results of the lacp info you wanted I got that same impression. I’ll reply back on Monday afternoon when I get the fiber cables in and see if I run into more problems.
Think I've narrowed this down significantly.I have 4 SFP-GE-T-E copper SFPs (no clue on brand, not obvious), and 4 LongLine GLC-T-LL copper SFPsFirst I discovered that if the fiber 10gig sfps are in, the switch won't even recognize the copper sfp lin...
Will do. Pretty sure when I first tried setting this up I used 1/1 and 1/3 since those were the non 10gig ports. But ran into the same exact scenario so then I extended it to all 4 sfp slots to widen the test base. i just got in the 10gig fiber sfp m...
